Vinyl wraps are attractive and durable compared to paint, but they do have one problem-bubbles. If you want to know how to get bubbles out of the vinyl wrap, you’re not alone – the solution is simple and can be found below!
Bubbles are formed when air gets under the vinyl wrap after installation, and it can ruin the look of your vehicle. Here is how to get bubbles out of the vinyl wrap safely before they form air pockets on your paint job.
The fastest way to get bubbles out of vinyl wrap is to simply remove it. Remove the air bubbles by peeling the vinyl off your vehicle, and reapply new vinyl. This may seem like a long process, but it’s necessary for preserving your paint job.
Steps on how to get bubbles out of the vinyl wrap
You can simply do this with your finger, but if you want a more permanent fix, try using a card or spoon. The trick is to go in at an angle and slowly rub across the bubble. If that doesn’t work, you can try to slowly peel the bubble away from the vinyl. This should work if it was just an accident that formed the bubble, but if it’s still there after your attempts, proceed to step 2.
Heat up your credit card
Take out your credit card and get it warm, this is best done with a hairdryer. It needs to be hot enough, so you can peel the vinyl wrap easily away from the card, but not so hot that you burn yourself.
Stick your credit card into the bubble with some water
Take your credit card with some water on it and stick it to the bubble firmly-but not too hard.
Hold for 6 seconds
Wait 6 seconds, and slowly peel back. If the bubble doesn’t come off, repeat step 3. If it does come off with no problem, take a damp paper towel and wipe away any excess water/vinyl that may have accumulated during this process.
Bow the wrap
This is a simple method that requires using a heat gun and bow tool to create tension on the vinyl wrap.
Heat it
Heat will cause the air pockets underneath your vinyl wrap to expand, pop and disappear. If you have bubbles on your vehicle from bubbling or peeling vinyl, simply use a heat gun to pop the bubbles.
Use Water
Another method for removing air pockets under your wrap is to wet it down with water before you apply heat to it. Much like the previous tip, this will expand the air pockets until they pop out.
Use A Press
If all else fails, you can use a press to get rid of air bubbles. Use the heat gun again to apply heat underneath the vinyl wrap, and put everything under pressure with a hydraulic press. This will force air pockets out from your car’s paint job and flatten the vinyl wrap.
Why is it important to get rid of the bubbles on your vinyl wrap?
It is critical to eliminate any bubbles from the vinyl since they might irritate the eyes. They also create an uneven and unsightly surface. Furthermore, if an individual tries to pull out the bubbles after installation, they might end up creating holes in the vinyl. For that reason, it is important to get rid of bubbles before they form.
